Ochre Gold Leaf Sprig nails
A fine Milky Ochre stem with leaves pressed either side over Ochre Sun, and one Bronze leaf breaking the run.
3 bottles: Ochre Sun, Milky Ochre and Bronze. Ochre Sun and Milky Ochre are close in tone, so the design is tonal rather than graphic. It shows up in daylight and softens indoors. The bottles are not all the same finish (crème, sheer and shimmer), so the pattern picks up light differently from the ground.
The oval shape is the soft one: no corners, no point, and a canvas that stays about the same width from cuticle to tip.
Make it yours
Bottles for this nail
Tap a bottle to open it on the shelfWhat you need
How to paint Ochre Gold Leaf Sprig nails
- 1 Buff, dehydrate and base coat, then cure. Two thin coats of Ochre Sun, curing each one.
- 2 Draw a fine Milky Ochre stem, press leaves off it either side, then add one Bronze leaf.
- 3 Gloss top coat, cure, then cuticle oil once it is out of the lamp.
Questions about Ochre Gold Leaf Sprig
Is Ochre Gold Leaf Sprig hard to do at home?
Yes, with a steady hand. The motif is freehand, so the first nail is usually the worst one. Budget around 45 minutes for a full set, and three colours means three chances for something to bleed, so cure between each one rather than working wet on wet.
What polish do I need for Ochre Gold Leaf Sprig?
3 bottles: Ochre Sun (crème), Milky Ochre (sheer) and Bronze (shimmer). Plus a base coat and a gloss top coat, which every design here assumes you already have.
Does Ochre Gold Leaf Sprig work on short nails?
Oval is one of the better shapes for a short nail: it lengthens the look of the bed without needing free edge to do it, so the design carries over unchanged.
Do I need a UV lamp for Ochre Gold Leaf Sprig?
Yes. Bronze only works as a gel — the effect depends on rubbing or setting the finish into a cured tacky layer, which air-dry polish never gives you.