Pearl Iris Leaf Sprig nails
A fine Snow White stem with leaves pressed either side over Pearl Iris, and one Iris Bloom leaf breaking the run.
3 bottles: Pearl Iris, Snow White and Iris Bloom. Pearl Iris and Snow White are close in tone, so the design is tonal rather than graphic. It shows up in daylight and softens indoors. The bottles are not all the same finish (shimmer and crème), so the pattern picks up light differently from the ground.
It sits on an oval, with walls that follow the finger and a tip rounded off, which flatters a short nail bed without needing much length and keeps the motif undistorted.
Make it yours
Bottles for this nail
Tap a bottle to open it on the shelfWhat you need
How to paint Pearl Iris Leaf Sprig nails
- 1 Buff, dehydrate and base coat, then cure. Two coats of Pearl Iris, floated on so the particles stay lying flat, and cure hard.
- 2 Draw a fine Snow White stem, press leaves off it either side, then add one Iris Bloom leaf.
- 3 Gloss top coat, cure, then cuticle oil once it is out of the lamp.
Questions about Pearl Iris Leaf Sprig
Is Pearl Iris Leaf Sprig hard to do at home?
Yes, with a steady hand. The motif is freehand, so the first nail is usually the worst one. Budget around 45 minutes for a full set, and three colours means three chances for something to bleed, so cure between each one rather than working wet on wet.
What polish do I need for Pearl Iris Leaf Sprig?
3 bottles: Pearl Iris (shimmer), Snow White (crème) and Iris Bloom (shimmer). Plus a base coat and a gloss top coat, which every design here assumes you already have.
Does Pearl Iris Leaf Sprig work on short nails?
Oval is one of the better shapes for a short nail: it lengthens the look of the bed without needing free edge to do it, so the design carries over unchanged.
Do I need a UV lamp for Pearl Iris Leaf Sprig?
Yes. Pearl Iris and Iris Bloom only work as a gel — the effect depends on rubbing or setting the finish into a cured tacky layer, which air-dry polish never gives you.