Tangerine 3D Bubbles nails
3D bubbles: clear domes built over Tangerine, each one catching its own highlight.
3 bottles: Tangerine, Milky Ochre and Rust Ember. Tangerine and Milky Ochre are close in tone, so the design is tonal rather than graphic. It shows up in daylight and softens indoors. The bottles are not all the same finish (crème and sheer), so the pattern picks up light differently from the ground.
Coffin nails give the most surface of any shape here, which is why the heavier finishes tend to live on them; they also need the most length to work at all.
Make it yours
Bottles for this nail
Tap a bottle to open it on the shelfWhat you need
How to paint Tangerine 3D Bubbles nails
- 1 Buff, dehydrate and base coat, then cure. Two thin coats of Tangerine, curing each one.
- 2 Place builder-gel domes on cured Tangerine and flash-cure each so it holds its shape.
- 3 Seal around each piece with gel glue and cure, checking nothing has a lifted edge.
Questions about Tangerine 3D Bubbles
Is Tangerine 3D Bubbles hard to do at home?
It is the hardest tier on the site. It is doable at home, but the technique is the point rather than the colour. Budget an hour or more for a full set, and three colours means three chances for something to bleed, so cure between each one rather than working wet on wet.
What polish do I need for Tangerine 3D Bubbles?
3 bottles: Tangerine (crème), Milky Ochre (sheer) and Rust Ember (crème). Plus a base coat and a gloss top coat, which every design here assumes you already have.
Does Tangerine 3D Bubbles work on short nails?
Coffin is the one shape here that genuinely needs length. On a short nail there is not enough free edge to cut square, and it will read as a squoval instead.
How many coats does Tangerine 3D Bubbles need?
More than you would expect. Milky Ochre is translucent, so the colour builds over three thin coats rather than covering in two. Stop wherever you like the depth — that is the point of a sheer.